Options Adjustments

Item

 

 

 

 

Adjustments

 

Off

1

2

3....

30

 

You can set the power-on delay time of the displays to reduce the power load, when you press POWER switch

 

to turn on the multiple displays that are set together.

 

Set each display’s setting individually.

 

Off:

 

The display will be turned on at the same time as POWER switch is pressed.

 

1 to 30 (sec.): Set the power-on delay time (second).

 

 

 

After pressing POWER switch, the display will be powered on with time delay depending on this

Power On Screen

Notes:

 

setting.

 

 

 

 

 

Delay

• During this function is working, the power indicator is blinking green.

•This function also works when the power recovers from failure or after plugging off and in again the power cord.

After you unplug and plug the power cord in while the unit is in standby mode and also the power is being supplied to a terminal board, the unit will start supplying the power to the board with time delay according to the setting.

The power indicator lights up red fi rst and it turns orange when the power starts being supplied to the board.

Off: Not display the clock.

On: Display the clock.

The clock is displayed at the lower left of the screen when button is pressed.

Clock Display

10:00

Note: When “PRESENT TIME SETUP” is not set, the clock is not displayed even if “Clock Display” is “On” (see page 25)

 

Sets All Aspect mode (advanced aspect setting) or default aspect mode.

 

With each press of

button, the aspect changes in the selected mode.

 

Off:

Default aspect mode

All Aspect

On:

All Aspect mode

Aspect mode of each setting is as follows:

 

 

(Example: HD signal)

 

 

Off

4:3 H-FILL

ZOOM FULL JUST

 

On

4:3 (1) 4:3 (2) 4:3 Full Zoom1 Zoom2 Zoom3 16:9 14:9 Just1 Just2

Serial Slot

Slot1

Slot2

Slot3

Selects the slot which communicates serial.

Select

Note: The setting of an external command can be set only from the fi xed serial terminal. (see page 11)

 

Normalization

When both main unit buttons and remote control are disabled due to the “Button lock”, “Remocon User level” or “Remote ID” adjustments, set all the values “Off” so that all the buttons are enabled again.

Press the –/▼button on main unit together with

button on the remote control and hold for more than 5 seconds. The

“SHIPPING” menu is displayed and the lock is released when it disappears.

36