20
Hotel Mode Setup

Display “Hotel Mode”

Press MENU, G, Y and 0 remote button.

Hotel Mode
Mode
TA Ctrl
Initial input
Initialchannel
Save
1/3
HDMI 1
101-1
On
External
select
Adjust

Select “Save” then press OK

Complete Hotel Mode setup

Hotel Mode
Mode
TA Ctrl
Initial input
Save
1/3
HDMI 1
On
External
select
ok

Operating restrictions can be set by setting the operating mode or initial settings in the “Hotel Mode”.

Hotel Mode menu (An underlined item is default setting)
Item Adjustments/Configurations (alternatives)
Mode
Sets operation mode Hotel mode(Guest mode) or Setup mode. (Off/On)
These settings are enabled even after the AC is switched off and on again.
On: These menu restrictions are enabled. Communication can be performed with TA (Online), and the
“Guest menu” (p. 34) is displayed. (Guest mode)
Off: These menu restrictions are disabled. Communication with TA cannot be performed, and the “Setup
menu” is displayed. (Setup mode)
TA Ctrl Sets TA (Terminal Adaptor) status. (External/Local Auth/Off)
External: Use External TA Local Auth: Local Authentication Mode is enabled by special procedure so it is not
visible in the default menu
Initial input Selects Input when the TV is turned on.
Does not operate when input from TA* to the TV is prohibited.
(-/RF/HDMI 1-2/Component/Video/PC/SD)
Initial channel Sets the channel at power-on.
Initial volume Sets the volume level at power-on. (0-100)
Does not operate when control from TA to the TV is prohibited.
Max. volume Sets the maximum volume level. (0-100)
OSD Ctrl
Limits the OSD display. (Off/Pattern1)
Pattern 1: “Recall” and “Shut-off notification” messages are not displayed at power-on.
Also displayed when “Pattern 1” is specified as the display command from TA.
Button lock Limits the TV panel button operation. (Off/All/Pattern1)
Pattern 1: Only INPUT and POWER buttons are available.
All: All buttons are not available.
Power ctrl Sets the screen condition when the AC power is switched on. (Off/On)
Off: Starts up in last screen. On: Starts up in screen On.
Remote Switches Operation guide according to remote control. (Panasonic/Others)
CC reset Sets CC setting status. (On/Off)
Off: Saves the last settings. On: Resets all CC settings to defaults.
Lock reset Sets Lock setting status. (Off/On)
Off: Saves the last settings. On: Resets all Lock settings to defaults.
CC Priority Select CC standard to be prioritized (EIA-708 or EIA-608). (708/608) (p. 42)
Com warning On: Hides warning panel of communication error when connecting with STB etc. (Off/On)
(Especially when connecting with GuestTek/nSTREAM Analog VOD system, switches this menu to “On” .)
Welcome Image Sets Welcome Image status. (3sec/5sec/7sec/Off/Load Image) Loading Welcome Image (p. 36)
CP Mode
On: When using input switching commands with RS232 connection while connected to STB, switch Menu to “On”. (Off/On)
HDMI Audio Sync Switch to Mode 2 if experiencing problem with HDMI audio. (Mode1/Mode2)
Decode mode Switch to Mode 2 if experiencing problem with RF picture and audio. (Mode1/Mode2)
* TA: Terminal Adapter