9
SERIALPC IN
AUDIO
SLOT1 SLOT2 SLOT3
VIDEO IN VIDEO OUT
P
R
/C
R
/R P
B
/C
B
/B
Y/G
AUDIO
RL
COMPONENT/RGB IN
AUDIO
IN
R L
AV
S VIDEO IN
12
1
3
2
1
21
2
Connections
SPEAKER
Terminal (R)
SPEAKER
Terminal (L)
– Cable fixing bands Secure any excess cables with bands as required.
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
Pass the attached cable
fixing band through the
clip as shown in the
figure.
To secure cables connected to Terminals, wrap the cable fixing band around them
then pass the pointed end through the locking block, as shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress (especially
in the power cord), firmly bind all cables with the supplied fixing band.
From SERIAL
Terminal on Computer
(see page 11)
From EXTERNAL
monitor terminal on
Computer (see page 10)
Optional Terminal
Board Insert Slot
(covered)
COMPONENT/RGB IN
and Audio IN Terminals
(see page12)
AV Terminals
(see page12)
Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
– AC cord fixing
Speakers (Optional accessories)
To tighten: To loosen:
Pull
Pull
Keep the knob
pressed.
Note: The power plug in the illustration may not be the type fitted to your set.
Push until the hook clicks.
2. Pull off.
1. Keep the knob pressed.
1Connect the AC cord plug to the Plasma Display.
2Fix the left side clamper.
3Fix the right side clamper.
Close
Open