46
FAQs
Problem Actions
Chaotic image, noisy
Change the setting of “P-NR” in the Picture Menu (to remove
noise). (p. 20)
Check nearby electrical products (car, motorcycle, fluorescent
lamp).
●
●
No image can be displayed Is “Colour” or “Contrast” in the Picture Menu set to the minimum?
(p. 20)
●
Blurry or distorted image
(no sound or low volume) Reset channel. (p. 27)●
Unusual image is displayed Turn off the TV with Mains power On / Off switch, then turn it on
again.
●
No sound is produced Is “Sound Mute” active? (p. 8)
Is the volume set to the minimum?
●
●
Sound level is low
or sound is distorted
Sound signal reception may be deteriorated.
Set “MPX” (p. 20) in the Sound Menu to “Mono”.
●
●
Sound is unusual
Set the sound setting of the connected equipment to “2ch L.PCM”.
Check the “HDMI1 / 3 Input” setting in the Sound Menu. (p. 20)
If digital sound connection has a problem, select analogue sound
connection. (p. 32, 43)
●
●
●
Pictures from external equipment
are unusual when the equipment
is connected via HDMI
Is the HDMI cable connected properly? (p. 43)
Turn Off the TV and equipment, then turn them On again.
Check an input signal from the equipment. (p. 44)
Use an equipment compliant with EIA/CEA-861/861B.
●
●
●
●
TV goes into “Standby mode”
Off Timer function is activated.
The TV enters “Standby mode” about 30 mins. after analogue
broadcasting ends.
●
●
The remote control does not
work
Are the batteries installed correctly? (p. 6)
Has the TV been switched On?
●
●
HDMI ScreenSoundOther