Panasonic TX-47P950A General Operation, Power Stand-by see, Multi Screen see

General Operation

Power (Stand-by) (see page 6)

The TV set must first be plugged into the wall out- let and turned on at the power switch.

Press this button to turn the TV set On from Standby mode, press it again to turn the TV set OFF to Standby mode.

Note:

•It is also possible to turn the TV set on from STANDBY mode by pressing the “Direct Programme Number Se- lection” Buttons (0-9) and the “Programme Number Up or Down” Button, either on the set or on the Remote Con- trol.

Off timer (see page 23)

Multi Screen (see page 29)

Aspect (see page 28)

Surround (see page 26, 27)

Normalization (see page 25, 27)

Programme Number Selection Press to select the next higher or lower Programme number.

Press to store settings in Tuning menu.

TEXT hold (see page 32) /Still (see page 29)

TEXT Index (see page 33) /Channel Search (see page 30)

5

REC VCR DVD

VCR/DVD CONTROL (see page 34)

TV/AV Mode Selection

Press to select TV, AV1, AV2, AV3 and AV4 input signal modes sequentially.

Remote control : TV/AV

AV1 AV2 AV3 AV4

Press to display AV1 - AV4 at the bot- tom of the screen. Each coloured but- ton corresponds to each input signals. For example, pressing the Red button selects AV1.

Direct programme Number

•Direct Programme Number Selection You can select the number directly by pressing the corresponding programme number buttons.

Programme Number 8	8
Programme Number 36....	3	6
Programme Number 124...	1	2	4

Note:

•When the Skip setting for Programme Number 100 through 125 is on, the channel selection time will be short- ened, and thus you can not input three digits at a time.

TV

11