Panduit PA22193A01 manual Dct, Cutting Tool, Part No. DCT

DCT

PA22193A01 REV.: 03 6-2004

CUTTING TOOL

For Cutting

PANDUCT Plastic Wiring Duct or Cover, and Heat Shrink Tubing

Part No. DCT

DUCT CUTTING TOOL

OPERATING INSTRUCTIONS

© Panduit Corp. 1996

BLADE

INSERT

DCT

HOOK

SPRING

LATCH

WARNING: SAFETY GLASSES MUST BE WORN AT ALL TIMES WHEN USING THE DCT TOOL.

USE CARE WHEN HANDLING TOOL; BLADE IS SHARP!

CAUTION: This precision tool has been engineered and designed for use with PANDUCT Plastic Wiring Duct or Cover, and Heat Shrink Tubing. It is not intended for use on any other products or materials.

OPERATION

1.Determine (mark) the cut location as required.

2.Release the handle latch at the end of the handles. The handle spring allows the handles to be normally open.

3.Position the cutting blade at the marked location and squeeze the handles together until the material is cut through, and the blade bottoms out in the blade insert. If the cut is not long enough, also cut from the opposite side, across from the first cut.

4.Latch the tool handles in the locked position when the tool is not being used and during transport.

REPLACEMENT PARTS

DCT-BLD	Blade Replacement Kit (includes replacement blade and insert)
DCT-RI	Replacement Insert (includes insert only)
Blade Replacement:		Unhook spring from hook on blade. Using a wide blade standard screwdriver and 10mm hex
		wrench, remove nut and screw. Slide blade upward, out of tool, and replace with new blade.
		Fasten using existing screw and nut. Remember to hook spring onto hook on blade.
Insert Replacement:		Carefully pry out existing insert. Apply a small amount of Loctite Black Max (or equivalent) to
		bottom of replacement insert. Place insert into lower jaw of tool with the slotted side up.

For Technical Support:

www.panduit.com/location/index.asp

www.panduit.com

Email: cs@panduit.com

Fax: 630-759-7532

Page: 1 of 1