ParaBody manual 503 EXS00 PEC DEC Attachment ASSEMBLYINSTRU~iONS Step #1

503EXS00 PEC DEC ATTACHMENT ASSEMBLYINSTRU~'iONS (STEP #1)

Attach eight ($) PARAGLIDESTRIPS to the BACKSUPPORTFRAMEas shown in DETAILon (STEP#I SHEET#I of#2), using the following steps:

A.ThoroughIyclean all inside and outside surfaces where the PARAGLIDESTR/PS~a'¢ to b¢ attached.

B.Remove the paper backing from the PARAGLIDESTRIPS ANDFIRMLYAPPLYthem to all of the shownsurfaces. (8 places)

13.Assemble the SPRINGPIN ASSEMBLYon the BACKSUPPORTFRAME~u~ing on(." (i) PLUNGER, one (1) KNOB,one (I) SPRING, one (I) SPACERand one (1) COTTERPIN. (SEE

14.Insert the I-I/'2 IN. SQ. ENDCAPinto the top end of the SPRINGPIN ASSEMBLYFIOUSINGon the

BACK SUPPORT FRAME. (SEE DETAIL A)

15.Securely assemble the BACKPAD, using two (2) 3."8 X 3 BOLTS,two (2) 3/8 LOCKWASHERS, t~vo (2) 3/8 WASHERS.

16.Insert one (I) 1-3:4 IN. SQ. ENDCAPinto the end of the SEATFRAME.

17.Disengage the SPRING PIN ASSEMBLYon the BACKSUI-PORT FRAMEand insert the SEAT PAD

ASSEMBLYinto the seat receptacle. Release the SPRINGPIN and push the SEATP.AD ASSEMBLY downuntil the SPRINGPIN PLUNGER~ngages with the desired hole.

18.Securely assemble the SEATPADto the SEATFRAME,.using~,vo (2) 3/8 X 2-.3/4 BOLTS,~vo (2) LOCKWASHERS.and two (2) 3/8 WASHERS.

NOTE: WHENDESII~ED SEAT LOCATION IS FOUND, SECURE IN PLACE USING ONE THUMBSCREW.(SEE DETAIL A)