Paradyne 6310-A4 !

1. Read and follow all warning notices and instructions marked on the product or

included in the manual.

2. Slots and openings in the cabinet are provided for ventilation. To ensure reliable

operation of the product and to protect it from overheating, these slots and

openings must not be blocked or covered.

3. Do not allow anything to rest on the power cord and do not locate th e product whe re

persons will walk on the power cord.

4. Do not attempt to service this product yourself, as opening or removing covers may

expose you to dangerous high voltage points or other risks. Refer all servicing to

qualified service personnel.

5. General purpose cables are used with this product for connection to the network.

Special cables, which may be required by the regulatory inspection authority f o r the

installation site, are the responsibility of the customer. Use a UL Listed, CSA

certified, minimum No. 24 AWG line cord for connection to the Digital Subscriber

Line (DSL) network.

6. When installed in the final configuration, the product must comply with the

applicable Safety Standards and regulatory requirements of the country in which it

is installed. If necessary, consult with the appropriate regulatory agencies and

inspection authorities to ensure compli ance.

7. A rare phenomenon can create a voltage potential between the earth grounds of

two or more buildings. If products installed in separate buildings are

interconnected, the voltage potential may cause a hazardo us c on dition. Consult a

qualified electrical consultant to determine whether or not this phenomenon exists

and, if necessary, implement corrective action prior to interconnecting the products.

8. Input power to this product must be provided by one of the following: (1) a UL

Listed/CSA certified power source with a Class 2 or Limited Power Source (LPS)

output for use in North America, or (2) a ce rtified transformer, with a Safety Extra

Low Voltage (SELV) output having a maximum of 240 VA available, for use in the

country of installation.

9. In addition, since the equipment is to be used with telecommunications circuits, tak e

the following precautions:

—Never install telephone wiring during a light ning storm.

—Never install telephone jacks in wet locations unless the jack is specifically

designed for wet locations.

—Never touch uninsulated telephone wires or terminals unles s the tele phone lin e

has been disconnected at the network interface.

—Use caution when installing or modifying telephone lines.

—Avoid using a telephone (other than a cordle ss type ) during a n electrical storm.

There may be a remote risk of electric shock from lightning.

—Do not use the telephone to report a gas leak in the vicinity of the leak.