Introduction
Congratulations on your purchase of your PAL-265 Precision Architectural Loudspeaker system and thank you for choosing Parasound. The PAL-265 Precision Architectural Loudspeakers were developed using the finest loudspeaker and crossover components available. Countless hours of computer modeling were spent to insure accurate audio reproduction in a variety of installations where placement compromises must sometimes be made. The PAL-265 Precision Architectural Loudspeakers mounted in your walls deliver the high-fidelity audio reproduction you have come to expect from high-end loudspeakers in a cabinet. Please take a few minutes to read these instructions thoroughly to make the installation easier and insure the best performance of your new PAL-265 Precision Architectural Loudspeakers.
Unpacking and Inspection
Carefully unpack your PAL-265 loudspeakers locate the enclosed accessories:
Item Qty Description
12 PAL-265 baffle and loudspeaker assembly
22 Metal grilles
32 Foam grille inserts
42 Paint Shields
Be sure to carefully inspect the speakers for any signs of shipping damage. If you believe you notice any, contact your Parasound Dealer immediately.
Precautions
If you have any doubts about your ability to properly install in-wall loudspeakers, you should consider the services of a custom installer. If you plan to install them yourself, always use good quality tools to save time and make the installation go more smoothly.
The PAL-265 Precision Architectural Loudspeakers mount into standard 4 inch (or greater) stud depth walls. Determine the final location of both left and right speakers before cutting any holes since changes to one speaker may affect the other either aesthetically or acoustically. Look for pipes, wiring or any other conflicting material that might be damaged before beginning the installation.
Prewiring
Before you purchase loudspeaker wire, check local building codes to make sure that the wire is rated to comply with applicable local safety codes such as UL or CL-2. Use only stranded wire no thinner than AWG 16. For runs longer than 100 feet, we recommend minimum of AWG 14. When pulling wire, take care not to pull the wire too fast to prevent stretching the wire or scorching the insulation from friction. Leave 2 to 3 feet of excess loudspeaker wire at both ends; it is easier to trim off excess wire than to splice additional wire. When securing the wire inside the walls, be careful not to pierce the insulation with nails or staples.
