Parkside PABS 10.8 A1 manual Introduction, Intended purpose, Equipment Components, Items supplied

Introduction

The following icons / symbols are used in this instruction manual:

Read instruction manual!	Keep children away from electrical
	power tools!
Observe caution and safety notes!	For indoor use only!
Caution – electric shock!	Check that the device, mains lead
Danger to life!	and plug are in good condition!
Explosive material!

Lithium-ion cordless drill	4	Bit garage
PABS 10.8 A1		Direction of rotation switch/lock
	5
	6	ON / OFF switch
	7	Soft-grip

Introduction

Before you use it for the first time, it is es- sential that you make yourself fully familiar

with the functions of the appliance and find out how to correctly handle electrically powered tools. Read the following directions for use as well as the safety instructions. Keep these instructions. When handing the device on to a third party, hand these instructions on, too.

8Battery pack

9Battery unlocking button

10 Light

11 Torque control / drill step

12 Quick-action drill chuck

13 Power supply unit

14 Status LED red

15 Battery charge status indicator green

16 Charging cap

Intended purpose

This appliance is designed for drilling and screwing into wood, plastic and metal. Use the appliance only as described and only for the purposes indicated.

Any other uses, and modifications to the appliance, are deemed to be improper usage and may result in serious physical injury. The manufacturer accepts no responsibility for damage(s) resulting from improper usage. The appliance is not intended for commercial use.

Equipment Components

1Gear selector switch

2Button for rechargeable battery LED

3Rechargeable battery LED (status indication)

Items supplied

1Cordless drill driver PABS 10.8-A1

1Rechargeable battery pack PABS 10.8-A1-1

1Power supply unit PABS 10.8-A1-2 with charging cap

2 Bits in bit garage (CR-VPH1, CR-VPH2)

1Carry case

1Directions for use

Technical Data

Lithium-Ion Cordless Drill PABS 10.8-A1:

Nominal voltage: 10.8 V

Idle-running speed: 1st gear: 400 min-12nd gear: 1300 min-1

Drill chuck
clamping range:	max. 10 mm

6GB/IE