Preparing for use / Maintenance and cleaning / Service centre / Warranty
Do not allow the ventilation slots to become covered.
Switch the device on first and only then bring it into contact with the workpiece.
If the saw blade jams, switch off the device im- mediately.
Open the sawn gap in the workpiece slightly using a suitable tool and extract the saw blade. Always make sure the saw blade type and the blade oscillation speed are suitable for the workpiece material.
There are different saw blades available in var- ious lengths designed to ensure optimum perfor- mance of every sawing task with your sabre saw. Saw the material using a steady forward rate of progress.
Flush sawing:
Using flexible saw blades of adequate length you can trim off projecting workpieces, such as pipes, directly at the face of a wall.
Follow these steps:
1.Place the saw blade directly on the wall surface.
2.Bend the blade by applying sideways pressure so that the shoe 5 comes up against the wall.
3.Switch on the device as described above and trim the workpiece using constant pressure.
Plunge sawing:
CAUTION! DANGER OF KICKBACK! Plunge sawing can be used only in soft materials (such as wood etc.).
Follow these steps:
1.Place the sabre saw with the underside of the shoe 5 against the workpiece.
Switch on the device.
2.Tilt the sabre saw forward and plunge the saw blade into the workpiece.
3.Bring the sabre saw vertical and continue saw- ing along the cutting line.
Note: The saw blade used for this should not be longer than 150 mm!
Maintenance and cleaning
Pull the mains lead out of the mains socket before you clean the device.
Replace the saw blade as soon as its teeth be- come blunt and it starts to produce defective saw cuts.
Always keep the device and the ventilation slots clean.
Clean the device after you have finished using it. Do not allow any liquids to enter the device. Use a cloth to clean the housing. Never use petrol, solvents or cleaning agents that might attack plastic.
If necessary, clean out the saw blade mounting recess
with a thin paintbrush or compressed air.
Service centre
WARNING! Have your device repaired only by qualified specialist personnel using original manufacturer parts only. This will ensure that your device remains safe to use.
WARNING! If the plug or mains lead needs to be replaced, always have the replacement carried out by the manufacturer or its service centre. This will ensure that your device remains safe to use.
Warranty
The warranty for this appliance is for 3 years from the date of purchase. The ap- pliance has been manufactured with care and meticulously examined before deliv- ery. Please retain your receipt as proof of purchase. In the event of a warranty claim, please make contact by telephone with our Service Department. Only in this way can a
GB/IE 11
