Introduction / General safety advice for electrical power tools
16Riving knife
17Sawdust removal connector
18Adapter for vacuum sawdust removal
19Cutting depth scale
20Auxiliary handle
21Drive spindle
22Mounting flange
23Clamping flange
24Clamping screw with plain washer
25Riving knife mounting
26Mounting screws
Included items
1 Circular saw
1 Guide fence
1 Adapter for vacuum sawdust removal
1 Allen key
1 Operating instructions
Technical information
Rated power: | 1300 W |
Rated voltage: | 230 V~, 50 Hz |
Saw blade: | 190 x 30 x 1.8 |
| (2.6 mm tooth thickness) |
Cutting depth: | 66 mm |
Protection class: | II / |
Noise and vibration data:
Measured values for noise are determined in ac- cordance with EN 60745. The
Sound pressure level: | 96 dB(A) |
Sound power level: | 107 dB(A) |
Uncertainty K: | 3 dB |
Wear ear protection!
Evaluated acceleration, typical: Hand / arm vibration ah = 3,447 m / s2 Uncertainty K = 1,5 m / s2
WARNING! The vibration level given in these instructions has been measured in accordance with a standardised measurement procedure specified in EN 60745 and can be used to compare devices.
Different uses of the device give rise to different vi- bration levels and in many cases they may exceed the values given in these instructions. It is easy to under- estimate the vibration load if the electrical power tool is used regularly in particular circumstances.
Note: If you wish to make an accurate assessment of the vibration loads experienced during a particular period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actually in use. This can result in a much lower vibration load over the whole of the period of working.
General safety advice for electrical power tools
WARNING! Read all the safety advice and instructions! Failure to observe the safety advice and instructions may result in electric shock, fire and / or serious injury.
Keep all the safety advice and instructions in a safe place for future reference!
The term “electrical tool” used in the safety advice refers to electrical tools powered by mains electrici- ty (by means of a mains lead) and electrical tools powered by rechargeable batteries (without a mains lead).
1. Workplace safety
a)Keep your working area clean and well lit. Untidy or poorly lit working areas can lead to accidents.
b)Do not work with the device
in potentially explosive envi- ronments in which there are
inflammable liquids, gases or dusts. Electrical power tools create sparks, which can ignite dusts or fumes.
GB/IE 7
