Parkside PSS 250 A1 Original ancillaries / and accessories, Switching On and Off, Vacuuming dust

General safety advice for electrical power tools / Operation

The appliance must always be kept clean, dry and free of oil or lubricat- ing greases.

Original ancillaries / and accessories

Only use accessories and tools that are specified in the operating instruc- tions. The use of tools and accessories other than those recommended in the operating in- structions could lead to an increased risk of personal injury for you.

Operation

Switching On and Off

Switching on intermittent function: Press the ON / OFF switch 1 .

Switching off intermittent function: Release the ON / OFF switch 1 .

Switching on continuous operation : Press the ON / OFF switch 1 , hold it pressed and press the locking button 2 .

Switching off continuous operation: Press the ON / OFF switch 1 then release it again.

Setting the oscillation speed

You can set the desired oscillation speed as need- ed with the oscillation speed selector 10 .

The required oscillation speed depends on the ma- terial being worked and can be determined through practical tests.

Attaching a sanding pad

WARNING! Before performing work on the appliance, always disconnect the power.

NOTE: Before attaching a new sanding pad 9 , remove dust and dirt from the sanding plate 8 .

Sanding sheets with hook and loop fas- tening:

Fix one side of the sanding sheet					9	flush with
one side of the backing plate			8	.
Then attach the sanding sheet					to the back-
			9
ing plate	8	and press it firmly into place.
Sanding sheets without hook and loop
fastening:
Open the two clamping levers			7		.

Push one end of the sanding sheet 9 under

the open clamping bar 6 and clamp the sheet firmly in place by locking the clamping lever 7 back in place.

Repeat this procedure at the other end.

Various materials require different grit values. You can read which grit value is best suited for which work in our recommendations under “Instructions, tips and tricks”.

Vacuuming dust

WARNING! FIRE HAZARD! A risk of fire exists when working with electrical appliances that have a dust

collection box 4 or can be attached to a vacuum cleaner via an external suction adapter! Under cer- tain conditions the sanding dust in the dust box (or in the vacuum’s dust bag) may self-ignite, e.g. as a result of flying sparks generated when abrading metals or metal objects left in wood. This can hap- pen especially if the wood dust has paint particles on it or is mixed with other chemical substances and the sanded material is hot after extensive work- ing. You should therefore avoid overheating of products being sanded as well as the appliance and always empty the dust collection box 4 or the dust bag of the vacuum cleaner before work pauses.

Wear a dust mask!

10 GB/IE