Patton electronic 1006 } }

8. Place the 2 halves of the strain relief assembly on either side

of the telephone wire and press together very lightly. Slide the

assembly so that it is about 2 inches from the terminal posts

and press together firmly. If your cable diameter is too small

or too large for our strain relief, please contact our technical

support. We have strain relief assemblies to accommodate

most cable diameters.

9. Insert the strain relief assembly with the wire going through it

into the slot in the bottom half of the modem case and set it

into the recess in the case.

4. Connect one pairof wires to XMT+ and XMT- (transmit positive

and negative) on the terminal block, making careful note of

which color is positive, and which color is negative.

5. Connect the other pairof wires to RCV+ and RCV- (receive

positive and negative) on the terminal block, again making

careful note of which color is positive and which color is

negative.

Ultimately, you will want to construct a two pair crossover cable

that connects the two short hauls as shown below:

6. If there is a shield around the telephone cable, it may be

connected to “G” on the terminal block. To avoid ground

loops, we recommend connecting the shield only at the

computer end. A ground wire is not necessaryfor proper

operation of the Model 1006.

7. When you finish connecting the wires to the terminal block, the

assembly should resemble the diagram below:

7 8

XMT + RCV+

XMT - RCV -

G G

RCV - XMT -

RCV + XMT +

To Shield (Optional)

}One Pair