Patton electronic 1092ARC user manual DSR During Local Line Loop, Response to Remote Digital Loop

4. DSR During Local Line Loop

Select Option 4 in the SOFTWARE CONFIGURATION to configure the behavior of the local Data Set Ready (DSR) signal during the Local Line Loop test mode (below).

5. Response to Remote Digital Loop

Select Option 5 in the SOFTWARE CONFIGURATION Menu to instruct the Model 1092ARC to either respond or ignore the Remote Digital Loop request from the remote 1092ARC.

6. DTE Controlled Local Line Loop

Select Option 6 in the SOFTWARE CONFIGURATION Menu to instruct the Model 1092ARC to either respond or ignore Local Line Loop requests from the DTE. To instruct the Model 1092ARC to respond to Local Line Loop requests from the DTE, select Enable (Option 1). To instruct the 1092ARC to ignore Local Line Loop requests from the DTE interface, select Disable (Option 2).

7. DTE Controlled Remote Digital Loop

Select Option 7 in the SOFTWARE CONFIGURATION Menu to enable DTE control of the Remote Digital Loop Menu (See below). The Remote Digital Loop on the 1092ARC can be controlled from the DTE interface by selecting Enable (Option 1). To instruct the 1092ARC to ignore this request from the DTE interface, select Disable (Option 2).

8. 2-Wire/4-Wire Selection

Select Option 8 in the SOFTWARE CONFIGURATION Menu to configure 2-Wire or 4-Wire operation.

*******************************************************

*	2-Wire/4-Wire Selection	*
*	1. 4-Wire Mode	*
*	2. 2-Wire Mode	*
*		*

*******************************************************

MAIN MENU Option 5: Select Hardware/Software Control

Select Option 5 from the MAIN MENU selects whether the Model 1092ARC will use the hardware switch settings or the software switch settings for its active configuration. If Options 1 or 2 are selected, the 1092ARC will use the current hardware or software switch settings as the active configuration. After changing this setting select MAIN MENU Option 8 to implement the changes.

17 18