Patton electronic 1203 user manual Radio And Tv Interference, Service, Features, Description

1.0 WARRANTY INFORMATION

Patton Electronics warrants all Model 1203 components to be free from defects, and will—at our option—repair or replace the product should it fail within one year from the first date of shipment.

This warranty is limited to defects in workmanship or materials, and does not cover customer damage, abuse or unauthorized modification. If this product fails or does not perform as warranted, your sole recourse shall be repair or replacement as described above. Under no condition shall Patton Electronics be liable for any damages incurred by the use of this product. These damages include, but are not limited to, the following: lost profits, lost savings and incidental or consequential damages arising from the use of or inability to use this product. Patton Electronics specifically disclaims all other warranties, expressed or implied, and the installation or use of this product shall be deemed an acceptance of these terms by the user.

1.1 RADIO AND TV INTERFERENCE

The Model 1203 generates and uses radio frequency energy, and if not installed and used properly—that is, in strict accordance with the manufacturer’s instructions—may cause interference to radio and television reception. If the Model 1203 does cause interference to radio or television reception, which can be determined by disconnecting the unit, the user is encouraged to try to correct the interference by one or more of the following measures: moving the computing equipment away from the receiver, re-orienting the receiving antenna and/or plugging the receiving equipment into a different AC outlet (such that the computing equipment and receiver are on different branches).

1.2 SERVICE

All warranty and non-warranty repairs must be returned freight prepaid and insured to Patton Electronics. All returns must have a Return Materials Authorization number on the outside of the shipping container. This number may be obtained from Patton Electronics Technical Service at (301) 975-1007. Packages received without an RMA number will not be accepted.

Patton Electronics’ technical staff is also available to answer any questions that might arise concerning the installation or use of your Model 1203. Technical Service hours: 8AM to 5PM EST, Monday through Friday.

2.0 GENERAL INFORMATION

Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is warranted for One Year parts and labor. If any questions or problems arise during installation or use of this product, please do not hesitate to contact Patton Electronics Customer Service at (301) 975-1007.

2.1 FEATURES

•Synchronous data rates to 224 Kbps

•Cable runs to 75 feet on each side of device

•Constant or RTS controlled carrier selections

•RTS-CTS delay options of 0mS or 6.6mS

•DB-25 connector on each end

•Half or full duplex

•Internal or external clocking

•No external power required

•LEDs monitor data and control signals

2.2 DESCRIPTION

The Patton Model 1203 high speed synchronous modem eliminator allows two synchronous RS-232 DTE (host) devices to communicate with each other without the need for expensive synchronous modems. Supporting selectable data rates of 7, 14, 28, 56, 112 and 224 Kbps, the Model 1203 needs no AC power or batteries for operation. The Model 1203 provides internal or external clock options and operates half or full duplex. To emulate dial-up or dedicated service, the delay between RTS and CTS can be set to either 0mS or 6.6mS. The carrier can be configured either as “constantly on” or “controlled by RTS”.

Measuring only 5.3” x 2.0” x 1.2”, the Model 1203 is equipped with a DB-25 connector on each end. Cable runs up to 75 feet on either side of the device (150 feet total) are possible at the optimum data rate of 64 Kbps. Tri-state LED indicators that monitor receive data, request to send and data carrier detect on each side of the device.

1 2