Introduction 41
Models 2603, 2621, and 2635 User Manual 4 • Ethernet LAN Port
Introduction
The Ethernet LAN interface/port can be configured with two IP addresses, a primary and a secondary IP
address. The configuration web page is found by following the path -> Services Configuration (in the Configu-
ration Menu) -> LAN -> ‘Change default LAN port IP address’ (button on the main window).
The Basic and Advanced Port Attributes of the Ethernet LAN port is found by clicking on the Ethernet hyper-
link in the OnSite’s Configuration Menu, the narrow window on the left-hand side of the web page. Clicking
on the View advanced attributes... hyperlink leads to a webpage with only a few parameters that could be of
interest. They are for controlling auto-negotiation, 100BaseT mode, and Full-duplex mode.
LAN Connections
The default LAN port’s IP address and netmask can be changed on this webpage. Go to -> Services Configura-
tion (in the Configuration Menu) -> LAN -> ‘Change default LAN port IP address’ (button on the main
window). (See figure 17.) The primary IP address and mask can be modified here, but if you do, you will no
longer be able to access the OnSite’s webpages with the previous IP address. The interface associated with the
Ethernet is named ip1. You can also configure a secondary IP address to the Ethernet LAN port.
Figure 17. Ethernet LAN port IP address configuration
The secondary IP address must be in the same subnet as the primary IP address. With primary and secondary
IP addresses, you can reach the OnSite’s webpages via either IP address. However you will have to login for
each separate IP address.
Ethernet Port
The Ethernet Port Configuration webpage provides a summ ary of the Ethernet port’s performance. You reach
it by clicking on the hyperlink Ethernet in the OnSite’s Configuration Menu window.
The Basic Port Attributes webpage displays the most commonly used Ethernet parameters for dete rmining the
performance of the Ethernet port (see figure 18 on page 42).