Manuals / Peavey / Home Audio / Speaker System

Peavey 15 D manual Frequency Response Curves, Amplitude Response, 1m On-Axis

Models: 15 D

1 16

Download 16 pages 2.25 Kb

Page 13

FREQUENCY RESPONSE CURVES

FREQUENCY RESPONSE CURVES

	110	Amplitude Response					(1m On-Axis)
	110
Pa)	100
Pa)
20	90
(re	80
dB SPL	80
dB SPL	70
	70
	6020	50	100	200	500	1k		2k	5k	10k	20k
	Figure 1				Frequency (Hz)
	Figure 1

13

Image 13

Peavey 15 D manual Frequency Response Curves, Amplitude Response, 1m On-Axis

Contents

PR15 D Powered bi-amplified two-wayspeaker systemOperating Manual CAUTION Risk of electrical shock - DO NOT OPEN IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONSDESCRIPTION FEATURESENGLISH PR 15D2ON-OFFSWITCH 1IEC POWER CORD CONNECTIONAPPLICATIONS FUSE8POWER/CLIP LED VOLUME4GROUND LIFT 5PRIMARY INPUT CHANNELO P E R A T I N G I N S T R U C T I O N S FLYING THE PR 15DCautions CONNECTING A SIGNAL TO THE PR 15D CONNECTING AC POWER TO THE PR15DVOLUME CONTROL ADJUSTMENT USE OF PR 15D WITH A SUBWOOFERTROUBLESHOOTING NO OUTPUT AT ALL MIC/LINE PAD ADJUSTMENTHUM OR BUZZ DISTORTED OR FUZZY SOUNDCLEANING CARE AND MAINTENANCEARCHITECTURAL AND ENGINEERING SPECIFICATIONS SUNLIGHT/HEATThe system power amplifiers shall have an unfiltered frequency response of 10 Hz to 30 kHz which deviates no more than +0, -1dB up to rated power, a damping factor greater than 100 @ 1 kHz into 8 ohms, hum and noise better than 90 dB below rated power, and THD and IMD of less than 0.1%. The woofer amplifier shall be capable of 150 W into a 8 ohm nominal load, and the tweeter amplifier shall be capable of 50 W output into a 8 ohm load, and both shall incorporate independent DDT compression Peavey PR15D SPECIFICATIONSAmplitude Response FREQUENCY RESPONSE CURVES1m On-Axis Page Product Category PEAVEY ELECTRONICS CORPORATION LIMITED WARRANTY2008