SPECIFICATIONS PD™ 4 Headphone Distribution System
The PD™ 4 allows connection of four stereo headphones to a power amplifier using resistor isolation on each output to prevent overloading the amplifier. If more outputs are required, any number of PD 4’s can be linked to meet your needs. The PD 4 also has a stereo/mono switch to allow a mono signal (connected
Caution: Care must always be taken when using headphones to prevent hearing damage.
SPECIFICATIONS:
Input:
Stereo
Output:
Four
Stereo/Mono Switch:
Stereo mode route stereo signal from input to outputs, mono position routes signal on tip of input to tip and ring of output jacks
Output Impedance:
22 Ohm, suitable for low or high impedance headphones
Dimensions (H x W x D): 4.4" x 3" x 1.5"
(11.18 cm x 7.62 cm x 3.81 cm)
Weight:
0.5 lbs. (23 kg)
80303113
Features and specifications subject to change without notice.
Peavey Electronics Corporation • 711 A Street • Meridian • MS • 39301 (601)