Peavey IDC 150T II manual Specifications, SPS eliminated, FCW attenuator setting

SPECIFICATIONS

(all measurements @ 120 V AC, 60 Hz or 24 V DC)

Rated Output Power: (typical value)

AC powered, continuous sine wave:

70 volt line 32.7 ohms, 1 kHz, 1% THD: 150 W RMS

25 volt line 4.2 ohms, 1 kHz, 1% THD: 150 W RMS

24 V DC battery powered, continuous sine wave: 70 volt 32.7 ohms, 1 kHz, 1% THD: 100 W RMS 25 volt 4.2 ohms, 1 kHz, 1% THD: 100 W RMS

Frequency Response: (typical value)

(SPS eliminated)

100 W RMS: +0, -1 db, 20 Hz to 15 kHz

Total Harmonic Distortion:

300 kHz bandwidth measurement; AC powered

(100 W RMS, 70 volt and 25 volt lines)

20 Hz to 15 kHz, below 0.15% THD

Signal-To-Noise Ratio:

(unweighted, 20 Hz to 22 kHz; FCW attenuator setting)

S/N below 103 db

Slew Rate: (typical value) 10 V/μs

Damping Factor: (typical value)

25 volt line; 1 kHz: 50

70 volt line; 1 kHz: 100

Input Impedance:

(FCW attenuator setting)

Balanced:	10 k ohms
Unbalanced:	10 k ohms

Input Sensitivity:

(FCW attenuator setting)

150 W RMS, rated output power Input voltage: 1.1 V RMS

Voltage Gain:

dBV 27 db

Dimensions & Weight:

Height: 5.25" (13.3cm)

Width: 19" (48.3cm)

Depth: 13" (43.2cm)

Weight: 32 lbs.

Protection Systems:

Thermal shutdown 100° C Current/Voltage limiting

Crowbar, on output to protect speakers from DC

Power Consumption:

Domestic model:

120 V AC, 60 Hz, 5 A, 600 W

24 V DC, 7 A

Export model:

230 V AC, 50 Hz, 2.6 A, 600 W

TM®

Due to our efforts for constant improvements,

features and specifications listed herein are subject to change without notice.

6