SPEAKER CONNECTIONS
This section will help you locate the two speaker output jacks on the rear of your MP 600. Though there are two output jacks, they are mono (parallel) and not stereo. (2 — 8 ohms speakers)
WARNING: NEVER ALLOW YOUR TOTAL SPEAKER IMPEDANCE TO DROP BELOW THE INDICATED MINIMUM IMPEDANCE.
4.SPEAKER OUTPUTS
Two parallel 1/4" jacks are provided at the output of the power amplifier. Minimum speaker
impedance (minimum load) is 4 ohms.
.
CHANNEL (1— 6) FEATURES
The following section describes Channels 1 — 6. Each of these input channels are identical. Some features listed below can be found on Channel 7 as well.
5.MIC INPUT
| XLR balanced low impedance channel input optimized for a |
| microphone or other low impedance source. Pin 2 is the positive |
10 | input. This connector has +15V phantom power supply on pins 2 |
| and 3 at all times. (Pin 1 is the ground reference.) |
9
8
7
6
5
WARNING: SOME PRODUCTS, INCLUDING SOME WIRELESS MICROPHONE UNITS, CAN BE DAMAGED BY PHANTOM POWER. CHECK THE OPERATING INSTRUCTIONS OF THE PRODUCT YOU WISH TO CONNECT TO THE MIC INPUT BEFORE CONNECTING. PHANTOM POWER DOESN’T AFFECT LOW IMPEDANCE DYNAMIC MICROPHONES.
6.LINE INPUT
1/4" unbalanced input that accepts line level sources equipped with a 1/4" plug (TS). The two inputs (XLR and 1/4") cannot be used simultaneously.
7.GAIN
Sets the level of the individual channel in the mix.
8.REVERB
Sets the level to internal reverb from channel and must be
used in conjunction with the master reverb level. It is post gain and will be affected by the Gain adjustment (7). The Reverb control also determines the level of signal sent to the Effects Output (14).
9.LOW EQ
A shelving type of active tone control that varies the bass frequency levels ±15 dB at 100 Hz. It will add depth to thin signals, or clean up muddy ones.
10.HIGH EQ
A shelving type of active tone control that varies the treble frequency level ±15 dB at 10 kHz. It is designed to remove noise or to add brilliance to the signal, depending on the quality of the source.
5
