Peavey Nitrobass manual Rear Panel Features, Power AMP in Jack, Power Cord Retainers

26.POWER AMP IN JACK

This 1/4" jack is used to input an external signal to the power amp section of the NitroBass. Using this jack will disconnect any signal from the preamp section. Using this jack along with the preamp out jack creates a possible second effects loop.

27 28 27

REAR PANEL FEATURES:

27.POWER CORD RETAINERS

Use the Power Cord Retainers to wrap and store your cable while storing or transporting your NitroBass. It is best to disconnect the cord from the unit before wrapping.

28.SPEAKER OUTPUT JACKS

These two 1/4" jacks provide the powered signal from the amplifier. Each connector is

electrically the same (in parallel). Use one of the jacks to connect your speaker cabinet and the other to add a second speaker cabinet in parallel. The minimum speaker load impedance is 2 ohms (or two 4-ohm speakers in parallel).

Warning: To prevent the amplifier from overheating, the front fan and rear-located vents should always remain clear of obstructions.

7