Peavey TKO, TNT manual Rear Panel, Power Switch

Rear Panel

14 15 16 17 18 19

11DDT™ (Distortion Detection Technique)

This button prevents power amplifier clipping that can sound bad and damage speakers. The “IN” or

%&'&"5
QPTJUJPO
PG
UIF
TXJUDI
CZQBTTFT
UIF
%%5
DJSDVJU

)PXFWFS
1FBWFZ¥
SFDPNNFOET
UIF
%%5
TUBZ
enabled for optimum system performance.

12HEADHPHONE OUTPUT


IFBEQIPOF
PVUQVU
GPS
QFSTPOBM
NPOJUPSJOH

13DDT INDICATOR LIGHT

8IFO
UIF
%%5
JT
FOBCMFE
UIF
1SPUFDU$MJQ

-&%
XJMM
øBTI
XIFO
%%5
JT
USJHHFSFE

*U
JT
OPSNBM
PQFSBUJPO
for the LED to flash. However, if the LED is constantly illuminated, the gain level needs to be adjusted to prevent possible equipment damage. When the DDT is defeated, the LED becomes a clip indicator.

14POWER SWITCH

To apply power to the unit, flip the switch to the “On” position. The blue LED will illuminate, indicating power is being supplied.

Caution: The on/off switch in this unit does not break both sides of the primary mains. Hazardous energy can be present inside the chassis even when the on/off switch is in the OFF position.

15AC POWER INLET:

This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to

this connector to provide power to the unit. Damage to the equipment may result if improper line volt- age is used. (See line voltage marking on unit).

Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a ground pin, a suitable grounding adapter should be used, and the third wire should be grounded properly. To prevent the risk of shock or fire hazard, always make sure that the amplifier and all associated equipment is properly grounded.

NOTE: FOR UK ONLY

As the colors of the wires in the mains lead of this apparatus may not correspond with the colored mark- ings identifying the terminals in your plug, proceed as follows: (1) The wire that is colored green and yel- low must be connected to the terminal that is marked by the letter E, or by the Earth symbol, or colored green or green and yellow. (2) The wire that is colored blue must be connected to the terminal that is marked with the letter N, or the color black. (3) The wire that is colored brown must be connected to the terminal that is marked with the letter L, or the color red.

12