Peerless-Premier PLP UN-1 manual Mounting Slots

3	Slide the vertical brackets (BB) along the c-channels of the adapter bracket (AA) until the slots on the back of the
	vertical brackets (BB) are aligned to the holes on the back of screen. Fully tighten the four 10-32 x 3/8" serrated

head socket pin screws (CC) which hold the vertical brackets (BB) to the c-channels. Refer to the accompanying screen compatibility chart to determine the proper fasteners to use. Attach the assembled adapter bracket to the back of the screen using screws, upper and lower spacers as pictured. Verify that all holes are properly aligned, then use the security allen wrench (LL) to tighten the screws.

Note: See figure 5 below for slot sizes.

Example: For a Toshiba model 50 HP82 50" screen, attach the vertical brackets (BB) to the screen using eight

M4 x 10 mm serrated socket pin screws (GG) or M5 x 12 mm socket pin screws (FF) through the small slots on the vertical brackets (BB). Please refer to the corresponding configuration note for more details. Upper spacers (JJ) are required for this configuration.

fig. 5

Mounting Slots

SMALL SLOTS ARE USED FOR M4 AND M5 SCREWS.

LARGE SLOTS ARE USED FOR M6 AND M8 SCREWS.

BB

C-CHANNNEL

MOUNTING SLOTS: SMALL

MOUNTING SLOTS: LARGE

AA SCREWS

UPPERSPACERS

LOWERSPACERS

4 of 4	ISSUED: 09-09-02 SHEET #: 200-9432-12 07-14-05
Visit the Peerless Web Site at www.peerlessmounts.com	For customer service call 1-800-729-0307 or 708-865-8870.

© 2004 Peerless Industries, Inc. All rights reserved.

Peerless is a registered trademark and Solid•Point is a trademark of Peerless Industries, Inc.

All other brand and product names are trademarks or registered trademarks of their respective owners.