Use a stud finder and follow the directions that come with it to locate the center point of the stud. Never mount into drywall
alone!
Slide wall bracket (C) along stud behind plasma mount leaving about half an inch between center of bottom hole of wall bracket (C) and top of plasma. Using the wall bracket (C) as a guide, mark and drill the four 5/32" (4 mm) dia. mounting holes in the center of the stud, 2 1/2" deep. At this point, it is essential to use a level to level your wall bracket (C). If it is only a few degrees off level, your shelf (A) will not sit straight.
Insert the four wood screws (D).
WARNING
•Tighten wood screws (D) so that wall bracket (C) is firmly attached, but do not overtighten. Overtightening can damage screws, greatly reducing their holding power.
•Never tighten in excess of 80 in • lb (9 N.M.).
•Make sure that mounting screws are anchored into the center of the studs. The use of an "edge to edge" stud finder is highly recommended.
C
Plasma
Approx. 1/2"
D C
2 of 3 | ISSUED: |
Visit the Peerless Web Site at www.peerlessindustries.com | For customer service call |
