Peerless Industries ST630P-S, 201-9421-10 Installation to Solid Concrete or Cinder Block, 5 of

Installation to Solid Concrete or Cinder Block

WARNING

•When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" of actual concrete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90 specifica- tions. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill to avoid breaking out the back of the hole when entering a void or cavity.

•Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.

•Make sure that the wall will safely support the combined load of the equipment and all attached hardware and components.

1	Make sure that tilt assembly (B) is level, use it as a
	template to mark two mounting holes. Drill two 1/4"

(6 mm) dia. holes to a minimum depth of 2-1/2"

(64 mm). Insert anchors (C) in holes flush with wall as shown (right). Place tilt assembly over anchors and secure with two #14 x 2-1/2" screws (G). Level, then tighten all fasteners.

WARNING

•Tighten screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage screws, greatly reducing their holding power.

•Never tighten in excess of 80 in. • lb (9 N.M.).

WARNING

•Always attach concrete expansion anchors directly to load-bearing concrete.

•Never attach concrete expansion anchors to concrete covered with plaster, drywall, or other finishing mate- rial. If mounting to concrete surfaces covered with a finishing surface is unavoidable, the finishing surface must be counterbored as shown below. Be sure concrete anchors do not pull away from concrete when tightening screws. If plaster/drywall is thicker than 5/8", custom fasteners must be supplied by installer.

1	concrete
	surface

C

Drill holes and insert anchors (C).

2	B
	G	C

Place assembly (B) over anchors (C) and secure with screws (G).

3

Tighten all fasteners.

SOLID
CONCRETE	CINDER
		BLOCK
C

		INCORRECT
VIEW	wall	concrete
	plate
CUTAWAY		plaster/
		dry wall

CORRECT

wall plate	concrete
	plaster/
	drywall

B

G

5 of 7 ISSUED: 04-27-05 SHEET #: 201-9421-10 10-27-09