HOOD
11• To fit the hood, push the handle rearwards, place the hood adjusting couplings onto the handle, then tie up the fastening strings as shown in the figure. To remove the hood, reverse operations.
12• The hood can be adjusted to two positions: To raise or lower it, push on the inner sides of the adjusting couplings and bring the hood up or down till the next click.
REMOVABLE LINING
13• To remove the lining from the car seat, detach the hood. Unfasten the safety belt and slip it out of the sack at the back.
14• Slip the fastener tabs on the sack out from under the car seat.
15• Slip the
•The hood is made of plastic, and can be washed without being removed.
INSTRUCTIONS FOR USE IN THE VEHICLE
IMPORTANT:
16•The "Primo Viaggio" car seat can be fastened to the front seat of a car that does not have an air bag system installed, or to the back seat of the car. The seat may be fastened using only
FASTENING THE BASE TO THE VEHICLE
17• Place the base for the child car seat on the seat of the vehicle. Since not all vehicle seats slope at the same angle, the
•The position of the base is correct when the bubble on the gauge is completely visible.
•To adjust the base, use one hand to turn knob A, and the other hand to push down on point B to simulate the childʼs weight. Adjust the base so
that the bubble is completely visible in the gauge. 18• Slip the vehicle seat belt through the two side
slots on the base, as shown in the figure.
19• Fasten the buckle to the vehicle seat, as shown in the figure.
20• If your vehicle is equipped with a seat belt with a
•Remove the Surefix Clip from its housing, as shown in the figure.
21• Grab the vehicle shoulder strap (the free strap) just above the buckle, and hold it taut while slipping the Surefix Clip onto the free strap, as shown in the figure. The Surefix Clip must hold the strap taut. (Once the Surefix Clip has been mounted correctly, it can be left on the vehicle seat belt to make it easier to fasten the base each time).
22• After mounting the Surefix Clip, check the tilt of the base again. If the bubble is not completely visible in the gauge, turn the knob again to tighten the belt.
•The base is ready for fastening the child car seat to it.
FASTENING THE CHILD CAR SEAT TO THE BASE IN THE VEHICLE
23• Place your child in the child car seat, and fasten the safety belt.
•The car seat must be positioned backwards, in relation to the direction of the vehicle.
•Fasten the car seat to the base, pressing with both hands until it clicks into place.
24• With the child car seat mounted in the vehicle, the handle on the seat must be lowered all the way against the back of the vehicle seat, as shown
in the figure. Push the handle until it clicks into place.
25• Pass the vehicle seat belt around the backrest of the child seat.
26• Slip the vehicle seat belt through the slot on the back of the seat, as shown in the figure.
27• Check to make sure that the seat belt is taut and securely fastened, for maximum safety.
•To remove the child car seat from the vehicle, remove the vehicle seat belt from the back of the child seat. Pull the handle until it clicks into place in an upright position, and unfasten the child seat from its base. Leave the base mounted in the vehicle, ready for use.
CLEANING & MAINTENANCE
Your product requires only minimal maintenance. Cleaning and maintenance operations must be performed only by adults.
•Be sure to keep all moving parts clean, lubricating them with light oil if necessary.
•Regularly clean the plastic parts with a damp cloth. Do not use solvents or similar products.
•Brush the fabric parts to remove dust.
