EN•ENGLISH
•IMPORTANT: read the instructions carefully before using the stroller. Save the instructions for future reference.
•PEG PEREGO reserves the right to make any necessary changes or improvements to the products shown at any time without notice.
CUSTOMER SERVICE
If parts of the model are accidentally lost or damaged, use only original Peg Perego spare parts. Contact the Peg Perego Customer Service for all repair work, replacements, information about products, and sale of original spare parts and accessories, at the following:
USA:
tel.: 800.671.1701
fax: 260.471.6332
Call us toll free: 1.800.671.1701
CANADA:
tel.: 905.839.3371
fax: 905.839.9542
Call us toll free: 1.800.661.5050
www.pegperego.com
INSTRUCTIONS FOR USE
OPENING
1• Before opening the stroller remove the
two protective caps from the hooks as shown in the figure. Otherwise, the stroller will not open correctly.
2• To open the stroller, pull up the two levers on the handles and
3• at the same time, lift the stroller, which will open automatically. To make sure that the stroller has been set up correctly, check the two side hooks (see figure).
ASSEMBLYING THE STROLLER
4• To mount the front wheels, lower Lever A and slip the wheels onto the axle, as shown in the figure. Press until the wheels click into place.
5• To mount the rear wheels, slip the wheels onto the axle, as shown in the figure. Press until the wheels click into place.
6• The stroller comes with caps on the armrests. To attach the front bar, remove the caps first. (Keep the caps, in case you want to use the stroller without the front bar). To remove the caps, press the buttons under the armrests while pulling the caps off.
7• To attach the front bar, insert the two ends of the bar into the armrests and
press until the bar clicks into place, as shown in the figure.
8• To mount the basket, slide the slots onto the front hooks A and the rear hooks B and C.
9• The figure shows the mounted basket. 10• The drink-holder can be attached to the left or the right handle of the stroller,
using the two bands.
• To mount the
11• Slide the clamp in the
Do not put hot drinks in the
PLIKO P3 VERSION
12• “Classico” Model: comes with a hood and front
HOOD
•The hood comes with a zipper, for attaching the
13• To mount the hood, push the fittings down until they click, as shown in the figure.
14• As shown in the figure, button the hood inside the armrest and the backrest of the stroller.
15• To stretch out the hood, push the compass downward. The hood can be reclined by following the inclination of the backrest.
16•The hood has a zipper on the back. With the zipper open, the hood can be used as a sun canopy.
17• To remove the hood, you must unbutton it from the stroller, loosen the couplings and raise the tabs of the fasteners, pushing towards the inside of the stroller.
BRAKE
18• To apply the brakes, push down with one foot the bars on the rear wheels, as shown in the figure. To release the brakes, draw the bar up. Always set the brakes on the stroller when it is not in motion.
SAFETY BELT
19• A: Make sure that the brace is properly inserted by pushing as shown in the figure. B: Fasten the belt as shown in the figure.
20• To unfasten the belt, press on the buckle sides and pull out the waist strap.
21• The new safety belt is now easier to fasten thanks to the
