8 C2496M-A (1/06)
CONNECT VIDEO AND POWER 1. Some indoor installations do not require a heater. If the installation does not require a heater,
disconnect the heater wiring.
a. Remove the cover with the supplied 1/8-inch hollow screwdriver bit.
b. Remove the camera from the mounting bracket, and unplug the four-pin heater
connector in the base. The connector has orange, red, and black wires.
c. Reinstall the camera. If the camera has a varifocal lens, leave the cover off; it will be
reinstalled later. Otherwise, reinstall the cover.
2. Depending on the input voltage, wire either the 12 VDC or 24 VAC connector (supplied) to the
input power wires. Plug the connector into the mating connector in the base.
3. Connect the video cable.
WARNING:
To prevent damage to the camera or lens, the camera must be installed in the
proper hole of the mounting bracket. If the camera is not installed in the correct hole, the
window of the enclosure may be forced against the lens.
COVER
TAMPER-
RESISTANT
SCREWS
CAMERA
MODULE
LOCK
WASHER
PHILLIPS
PAN HEAD
SCREW
BASE
VENT
MOUNT CAMERAS WITH
6, 8, AND 12 MM AND
VARIFOCAL LENSES
MOUNT CAMERAS WITH
2.9 AND 3.6 MM LENSES