Pelco c06hwc operation manual

PELCO • 3500 Pelco Way, Clovis, CA 93612-5699 • (559) 292-1981 • (800) 289-9100
FAX (800) 289-9150 or (559) 292-3827
®
C06HWC
Pre-wired Interconnecting
Cable
Installation/Operation
Manual C940M-C (9/95)
1.0 SCOPE
The information within this manual covers the installa-
tion and operation of the C06HWC pre-wired intercon-
necting cable.
Prior to installation and use of this product, the follow-
ing WARNINGS should be observed.
1. Installation and Servicing should only be
done by Qualified Service Personnel.
2. The installation shall be done in accordance
with all local and national electrical and
mechanical codes utilizing only approved
materials.
3. Unless the cable is specifically marked “WA”
(for use in wet locations), the cable is de-
signed for indoor use only and it must not be
installed where exposed to rain and mois-
ture.
Please thoroughly familiarize yourself with the infor-
mation in this manual prior to installation and operation.
2.0 DESCRIPTION
The C06HWC is a pre-wired 6 foot cable designed for
use with Pelco hard-wire controls for pan/tilts, scanners
and motorized lenses. The pre-wired cable is supplied
with a 14-pin control connector on one end and butt
splices on the mating end for the pan/tilt or lens, allow-
ing for a quick and easy field installation. Compatible
controls are listed below:
*MLZ6DT *MLZA6DT MPT24DT
MPT24DT/220 MPTA24DT MPTA24DT/220
MPT115DT MPTA115DT MPT220DT
MPTA220DT PT506-24DT PT506-24A
PT506-24DT/220 PT506-24A/220
*Compatible only when not used with the AI700
(Auto-iris).