2PELCO Manual C940M-C (9/95)
3.0 SPECIFICATIONS
ELECTRICAL
Connectors:
Control side: 14 pins
Pan and tilt/
Lens side: Butt splices
Cable: 12 conductor
GENERAL
Dimensions: 6 ft (1.83 m) long
Maximum Wire
Temperature: 140° F (60° C)
4.0 INSTALLATION
1. Splice the cable to the pan/tilt and or lens using
the butt splices provided.
2. Connect the 14-pin CPC connector to the control-
ler.
3. Operate the control unit and determine correct op-
eration of the pan/tilt or lens. If the unit fails to
operate correctly, refer to the troubleshooting
guidelines outlined in Section 6.0.
5.0 OPERATION
By using the controller, you should be able to control
the pan and tilt functions of the pan/tilt and/or the fo-
cus, iris, and zoom functions of the motor operated lens.
5.1 SYSTEM TEST
Using the controller, operate the following functions
(if applicable) and verify correct operation of each func-
tion:
1. Pan Left
2. Pan Right
3. Tilt Up
4. Tilt Down
5. Zoom Wide
6. Zoom Tele
7. Iris Open
8. Iris Closed
9. Focus Near
10. Focus Far
11. Preset Operation (optional on pan/tilt and dome)
12. Camera Power
13. Enclosure Power
14. Camera Sync
If all the above functions operate correctly, the instal-
lation process is complete. If all the above functions do
not operate correctly, refer to Section 6.0, Troubleshoot-
ing Guidelines.