Pelco Manual C1431M-C (8/04) 7
7. Install the sled and camera/lens in the enclosure:
a. If the camera’s lens is adjustable, extend the lens to its maximum length.
b. Place the sled over the mounting screws in the enclosure.
c. Slide the sled forward until the camera’s lens almost touches the window.
d. Tighten the screws to secure the camera sled to the enclosure.
8. Wire the video output from the camera.
9. If you are going to synchronize cameras, wire the camera’s synchronization
connection.
10. If your camera has a motorized zoom lens control, wire it.
EH5723 and EH5729 Models Only – Wire the camera’s lens control
directly to the lens controller.
EH5723-1, -2, -3 Models, and EH5729 -1, -2, -3 Models Only –
Refer to Figure 2 and wire the motorized zoom lens control as follows:
a. Connect or wire the lens control from the camera to the LENS or LENS
CONTROL connector on the circuit board.
b. Wire the 10-connector INPUTS terminal on the circuit board to the lens
controller as follows:
• Lens Common - Connector 1
•Focus - Connector 2
•Zoom - Connector 3
•Iris - Connector 4
•Preset Common - Connector 5
•Preset Focus - Connector 6
•Preset Zoom - Connector 7
•Preset High - Connector 8
11. EH5723-1, -2, -3 Models, and EH5729 -1, -2, -3 Models Only –
Refer to Figure 2 and connect the camera’s power input to the circuit board.
There are two ways to supply power to the camera - when the power require-
ments for the camera and enclosure’s accessories are the same (for example,
if the camera and accessories use 24 VAC), and when the power require-
ments for the camera and the enclosure’s accessories are different (for ex-
ample, if the camera uses 24 VAC and the accessories use 120 VAC).