26 Pelco Manual C573M-D (11/03)SET UNIT ID
To enter the MDA unit for which you want to assign or modify settings, click Edit on the
CM9760-MDA SETUP dialog box and then click Unit ID. The Unit ID dialog box, Figure 20,
appears.
Enter the Unit ID number (1-64), and then click OK.
SET SYSTEM
The System menu allows you to set up communication ports for the CM9760-MDA and the
PC and to reset MDA software to factory default settings.
CM9760-MDA Communication: To set up the communication port for the
CM9760-MDA unit, click System on the CM9760-MDA SETUP dialog box and then click
MDA COM1 Setup. The MDA COM 1 Setup dialog box, Figure 21, appears.
Figure 20. Unit ID Dialog Box
CAUTION:
Be careful
when changing
the selections on the
CM9760-MDA ports. You
could accidentally change
the port setting and lose
communication with your
system!
Set communication parameters for the COM 1 port of the CM9760-MDA as follows:
1. Select the baud rate by clicking the option button next to the desired setting. The
default is 9600.
2. Select the parity by clicking the option button next to the desired setting. The default is
Even.
3. Enter the unit ID number of the MDA to which you are sending the data. The unit ID
number ranges from 1 to 64. The default is 1.
4. Click OK.
A Warning dialog box appears indicating that the CM9760-MDA COM 1 port settings
will be changed and that the PC serial port settings will be updated accordingly.
5. Click OK.
A confirmation dialog box appears indicating that the MDA COM 1 port settings were
changed.
Figure 21. MDA COM 1 Setup Dialog Box
NOTE:
The baud rate and
parity settings of the con-
nected CM9760-MDA
COM 1 port and PC port
must match.