16 C1603M (6/04)
c. Press down firmly to ensure that the label properly adheres to the inside of the door.
NOTE: In the event that your unit or its components require service, part labels must be present and
appropriately affixed to the unit’s door. Pelco product support personnel use these labels to identify
the exact components installed in your system. A separate part label is required for each upgrade
component installed on the DX8000.
ON/OFF
DX8000-ISCI
04111-48E-ED02
Figure 15. Product Label
4. Reinstall the unit in a rack enclosure if necessary and reconnect all cables and peripheral equipment that you
removed earlier.
5. Replace the unit’s power cord.
6. Turn on the power switch and allow the unit to start up and find the new hardware. This may take several minutes.
Figure 16. Restarting the Unit
7. Wait while the Windows® operating system finds SCSI card. This may take several minutes.
NOTE: All driver software required to install and operate the DX8000-ISCI SCSI adapter has been
preinstalled on your DVR. Do not attempt to install any driver, utility, or application software that came
with the SCSI card.