Pelco C1690M (9/05) , OPTIONAL: VERIFYING THAT THE SERVICE UPDATE PATCH IS CORRECTLY INSTALLED

Pelco Worldwide Headquarters • 3500 Pelco Way • Clovis, California 93612 USA • www.pelco.com
USA & Canada • Tel: 800/289-9100 • Fax: 800/289-9150
International • Tel: 1-559/292-1981 • Fax: 1-559/348-1120
Pelco and the Pelco logo are registered trademarks of Pelco. ©Copyright 2005, Pelco. All rights reserved.
Windows is a registered trademark of Microsoft Corporation.
Figure 4. Installation Is Completed Successfully Dialog Box
e. Click Finished.
8. Remove the DX8000 Resource CD.
9. To restart the DX8000 system, do the following:
a. On the Windows task bar, click Start. The Start menu is displayed.
b. Click Shut Down. The Shut Down Windows dialog box opens.
c. In the drop-down box, select Restart.
d. Click OK. The DX8000 system restarts and is ready for operation.
You can perform an optional step to verify that the service update patch is correctly installed. For more information, refer to Optional:
Verifying that the Service Update Patch Is Correctly Installed , next.
e. Log into the DX8000.
OPTIONAL: VERIFYING THAT THE SERVICE UPDATE PATCH IS CORRECTLY INSTALLED
To verify that the service update patch is correct installed:
1. Log in as Admin.
2. From the DX8000 File menu, click Exit. The Shut Down dialog box opens.
3. In the drop-down selection box, select Exit to Windows.
4. Click OK.
5. Click Start > Settings > Control panel. The Control Panel window is displayed.
6. Double Click Add/Remove Programs. The Add/Remove Programs dialog box opens.
7. Verify that the service update titled “DX8000 Patch v1.0.00.3” is listed as a currently installed program.
8. Close all dialog boxes.
9. Click Start > Programs > DX8000 to start the DX8000 application. The DX8000 application window opens.
10. Log back into the DX8000 to resume its use.