Pelco C1993M INSTALLATION

INSTALLATION

To properly install the VIEWSTN/1 Public Viewing Station refer to Figure 1 and do the following:

1Prepare Wiring/Cabling

a. Feed the monitor power cable through the top of the swivel collar and out the monitor

feedthrough hole.

b. Feed the video cable (not provided) through the camera feedthrough and out the

monitor feedthrough hole.

c. Pull wires for camera power through the top of the swivel collar and out the camera

feedthrough hole.

2Install Mount Arm

a. Apply anti-seize to the threads of the NPT pipe. Thread the swivel collar (at the top of

the mount arm) onto a 1 1/2-inch NPT pipe (not provided).

b. Tighten the top set screw on the swivel collar to secure the mount to the NPT pipe.

3Attach Monitor Rack

a. Place the monitor rack onto the bottom of the mount arm. Refer to the

b. Secure the monitor rack to the mount arm with the supplied Allen head bolts and

washers. Install one 5/16-18 x .75-inch bolt and locking washer and two 10-32 x

.50-inch bolts and flat washers to each side of the monitor rack.

4Install Monitor

a. Remove back feet of monitor and save the screws.

b. Slide the monitor onto the monitor rack. For proper installation, the back of the monitor

should be under the lip of the rack and the front feet of the monitor should be in the

holes in the front of the rack. Refer to the

c. Use the screws from the back monitor feet to secure the back of the monitor to the

rack. Insert the screws through the bottom of the monitor rack and into the holes used

previously for the back monitor feet.

d. Connect the video cable to the BNC video input on the rear panel of the monitor.

e. Plug the power cable into the AC INLET connection on the rear panel.

5Install Camera

a. Connect video cable and power wires. Push cable and wires back into the mount arm.

b. Set camera assembly over the camera mounting collar. Gently tighten the set screw in

the collar to lightly secure the camera to the mount. Refer to the

6Final Adjustments

a. Monitor Rack - Tilt monitor to desired position. Tighten the Allen head bolts to secure

the monitor.

b. Mount Arm - Turn mount arm to desired position. Tighten the bottom set screw on the

swivel collar to secure in place.

c. Camera - To adjust the camera, loosen the camera collar set screw and adjust the ball

and swivel assembly. When the camera is in the ideal viewing position, tighten the set

screw.