8Pelco Installation Manual C2429M (3/01)
STEP 3 - INSTALL DOME DRIVE
TO USE YOUR DOME, REFER TO THE OPERATION AND
PROGRAMMING MANUAL.
b.Line up the green and red tabs with the green and red labels.
Push in on the tabs. Insert the side with the green tab, then the
side with red tab. Continue pushing on the ends of the tabs
until both sides click into place.
LABEL
SW1
LABEL
SW2
SW1
SW2
RS-422 TERMINATION SWITCH
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
SW2
00538
GREEN
TAB
RED
TAB
00539
a.Set the DIP switches for SW1 and SW2 on the bottom of the
dome drive for the appropriate receiver address. Refer to the
labels on the dome drive or tables C through E in the Appendix
in the back of this manual.
0054
3
STEP 4 - INSTALL LOWER DOME
a.Lightly apply O-ring lubricant to the O-ring. Install the O-ring in
the groove on the trim ring of the lower dome.
Attach the back box trim leash to a retainer screw inside the
lower dome.
Environmental Model only: Plug the two-pin heater
connection in the lower dome into the mating connector in the
back box.
BARREL
LOCK
CENTER
PIN
00496
HEATER
CONNECTORS
O-RING
TRIM
LEASH
b. Align barrel locks in lower dome with the holes located on each
side of the back box. Push lower dome onto back box. Press
the pins of the barrel locks IN to secure the
lower dome.