Pelco C2453M-D (2/06) INSTALL THE MONITOR BATTERIES

C2453M-D (2/06) 7
INSTALL THE MONITOR BATTERIES
The battery pack located on the back of the monitor holds 8 AA or 10 NiCad rechargeable batteries
(batteries not included). To install the batteries, do the following:
1. Remove the mointor from the monitor compartment of the IPS-RMK (refer to Figure 1).
2. Press the tab located on the bottom of the battery pack of the monitor (refer to Figure 2).
3. Gently lift the battery back.
4. Install batteries.
5. Set the battery selection switch (refer to Figure 3).
6. Reinstall the battery pack onto the monitor.
Figure 2. Battery Compartment
Figure 3. Battery Selection Switch Location and Settings
WARNING: Never use a DC power supply when batteries are installed.
PRESS TAB AND
LIFT TO REMOVE
BATTERY BACK.
ALKALINE X 8EA
NICAD X 1OEA
ALKALINE X 8EA
NICAD X 1OEA
SET THE
BATTERY
SELECTION
SWITCH
= ALKALINE
= NICAD