Prepare Mounting Surface

NOTE: Minimum recom- mendation for mounting hardware is 1/4-20 X 5/8 Hex Head Bolt Stainless Steel, 1/4" Split Lock Washer Stain- less Steel, and 1/4" Flat Washer Stainless Steel with 1" Outer Diameter.

1.Determine the mounting location. Make sure the mounting surface can support four times the combined weight of the scanner and the camera and lens or enclosure, camera, and lens. Refer to the manuals for your enclosure, camera, and lens for the weights of those units.

2.If mounting directly to a flat surface, use Figure 1 as a template and mark the bolt and cable/wire feedthrough positions onto the installation surface. Prepare the mounting surface and pull cable/wiring for the scanner.

BOLT

HOLE

BOLT	SCANNER	BOLT
	FEED THRU
HOLE		HOLE
	HOLE

BOLT

HOLE

00814

Pelco Prepare Mounting Surface, PS20 Surface Mount Template Pelco Manual C361M-A 8/02

Models: C361M-A

PREPARE MOUNTING SURFACE

Figure 1. PS20 Surface Mount Template

Pelco Manual C361M-A (8/02)