Pelco Manual C497M-D (1/96) 3
3.0 INSTALLATION
The following hardware is supplied with the enclosure
and can be used to mount the enclosure or the camera/
lens:
Quantity Item
2 1/4-20 x .500 hex head screws
4 1/4 flat washers
4 1/4 split washers
2 1/4-20 “tampruf” screws
3.1 CAMERA/LENS INSTALLATION
1. Remove the four (4) “tampruf” screws from the
rear cap with the tool provided.
2. Remove the rear cap from the enclosure. Loosen
the bolt on the camera sled assembly and remove
it from the rail.
3. Place the camera/lens on the sled assembly.
NOTE: Position the camera/lens at the
forward-most point on the sled, while al-
lowing clearance between the lens and en-
closure window when the lens is adjusted
to its maximum physical length.
4. Secure the camera/lens to the sled with the 1/4-20
hex head screws provided.
5. Pull the video and power cables through the knock-
outs and attach to the camera.
6. Adjust camera focus and iris if necessary.
7. Replace the sled onto the rail and slide the assem-
bly into the enclosure; replace the bolt and secure.
8. Replace the rear cap and the four (4) “tampruf”
screws.
9. Attach the enclosure to the appropriate mount or
pan/tilt using the instructions provided.
NOTE: If the lens needs to be adjusted fur-
ther after installation has been completed, it is
easier to remove the front cap to make final lens
adjustments.