Pelco C505M-B, CX9504 A, B

If you did not order a pre-assembled connector, assemble the connector parts ac-

cording to the instructions below. Detail B, below, reflects the pin arrangement spe-

cific to CX9500/CX9504 Receivers. Refer to Figure 4 during assembly. For best

results use an AMP style crimper when making the wire to pin connection.

The instructions that follow apply to all AMP style connectors regardless of pin size

or pin number.

1. Slide the connector clamp assembly over the conductor cable. If the diameter

of the conductor cable is such that the rubber boot will slide over it easily, then

slide the rubber boot onto the conductor cable at this time. If not, discard the

rubber boot.

2. Prepare the wires from the conductor cable as follows:

a. Strip at least 1" from the cable jacket to expose the wires. You may need

to strip more from the cable jacket if you have more wires.

b. Strip 1/8" from each wire.

c. Using an AMP style crimper, crimp the wires and their insulation to the

connector pins. Refer to Detail A in Figure 4.

3. Slide the connector pins into the appropriate holes in the connector body until

they snap into place. The connector holes are numbered for your convenience.

4. Push the connector clamp assembly (with boot, if used) toward the connector

body. Screw the clamp assembly onto the connector body, being careful not to

disturb the wires.

5. To complete the assembly, attach the appropriate clamp with the screws pro-

vided and tighten.

NOTE:

00009

A

00001

15 10

22 16

28 23

33 29

37 34