18 C611M-C (3/06)
Connecting to the Network
To connect the NVR300 to the network, refer to Figure 7 and do the following:
1. Connect one end of an RJ-45 network cable to the 1000BaseT Ethernet port of the NVR300.
2. Connect the other end of the cable to the network (typically to an Ethernet switch).
Figure 7. Network Connections
Connecting DX9200HDDI Video Storage Units (Certain NVR300 Models Only)
For expanded storage of NVR300 recordings, two SCSI ports are provided on the rear panel of certain models of the NVR300 (refer to Table A for
a list of the applicable models). Each SCSI port can connect to a DX9200HDDI video storage unit. For instructions on how to connect
DX9200HDDI video storage units to the NVR300, refer to Adding External Storage with DX9200HDDI Video Storage Units in the System Upgrade
section. For detailed information about DX9200HDDI video storage units, refer to the DX9200HDDI Series IDE Video Storage Unit Installation/
Operation manual.
Connecting the Power Cord
Connect the NVR300 power cord to the power input of the NVR300 (refer to Figure 8) and then to an uninterruptible power supply (UPS).
NOTE: It is recommended that the NVR300 be connected to a UPS to prevent corruption of data during a power loss; however, do not install
UPS-speciļ¬c software.
Figure 8. Power Cord Connection
2
ETHERNET SWITCH
2
POWER
CONNECTION