Routine Servicing
Never touch the surface of the lens.
Remove dust from the lens using a soft brush or clean compressed air. Avoid touching the lens surface during handling.
To remove fingerprints or oil stains from the lens surface, use lens cleaning paper or a clean cotton cloth with a little cleaning liquid. Then, wipe off the stains using a light circular motion, starting from the center of the lens surface. Wipe the lens body with a silicon cloth. Do not use any organic solvents such as thinner or benzene.
Lens and Connector Wiring Diagrams
Pelco VD Type Lenses
TO CAMERA
4 2
3 1
3
4
2
1
|
|
| DRIVE ( + ) | RED |
|
|
| ||
|
|
| DRIVE ( – ) | BLACK |
|
|
| ||
| CONTROL ( + ) | G IRIS | ||
| YELLOW | |||
| ||||
| CONTROL ( – ) | GREEN | ||
| ||||
|
|
|
|
|
| CABLE | |
(REAR OF PLUG, SOLDER LUGS) |
| |
|
|
Pelco VV Type Lenses
TO CAMERA
42
31
1
4
3
|
|
| DC+ | RED | |
|
| ||||
|
|
| GROUND | BLACK | |
|
|
| |||
|
|
|
| VIDEO | WHITE |
|
|
|
| ||
|
|
| REMOTE | GREEN | |
|
AUTO-
IRIS
CIRCUIT
G IRIS
(REAR OF PLUG, SOLDER LUGS) |
|
|
Specifications
Technical specifications are available from Pelco by any of the following methods:
•Product Specification Book
•Pelco’s B.O.S.S.® Software
•Web Site, Pelco Online at www.pelco.com
(Design and product specifications subject to change without notice.)
This equipment contains electrical or electronic components that must be recycled properly to comply with Directive 2002/96/EC of the European Union regarding the disposal of waste electrical and electronic equipment (WEEE). Contact your local dealer for procedures for recycling this equipment.
REVISION HISTORY
Manual # | Date | Comments |
|
11/05 | Added information on VDIR lenses. Reformatted manual. |
| |
Pelco and the Pelco logo are registered trademarks of Pelco. | ©Copyright 2005, Pelco. All rights reserved. |
Worldwide Headquarters • 3500 Pelco Way • Clovis, California 93612 USA • www.pelco.com
USA & Canada • Tel:
International • Tel: