Pelco Manual C1471M (10/98) 21
Scan Limit Stops
Refer to the documentation for your control system for programming presets, then
do the following:
1. Make sure limit stops are turned ON (refer to Section 4.7.11.1), then exit the
menu.
2. Push the joystick left until you reach the limit you want the camera to go to on
the left.
3. Program preset 92 (25).
4. Push the joystick right to the limit you want the camera to go to on the right.
5. Program preset 93 (26).
Setting presets 92 (25) and 93 (26) to the same point disables scan limit stops.
4.7.12 Park Time Minutes
This feature parks the dome at preset 1 after a programmed number of minutes of
control inactivity. You can set the time from 1 to 720 minutes (12 hours). Setting the
time to zero disables this feature. To change the park time:
1. On the main menu, move the joystick up or down to position the cursor (>)
beside Other.
2. Press the Iris Open button to enter the Other submenu.
3. Move the joystick up or down to position the cursor beside Park Time Minutes.
4. Press the Iris Open button. The cursor moves to the right beside the current
park time.
5. Move the joystick up or down to change the park time.
6. SELECT – Press the Iris Open button to select your choice.
CANCEL – Press the Iris Close button if you do not want to change the setting.
4.7.13 Scan Speed
Scan speed is adjustable from 1-40 degrees per second, and occurs in three scan
modes: auto, random, and frame. To change the scan speed:
1. On the main menu, move the joystick up or down to position the cursor (>)
beside Other.
2. Press the Iris Open button to enter the Other submenu.
3. Move the joystick up or down to position the cursor beside Scan Speed deg/s.
4. Press the Iris Open button. The cursor moves to the right beside the current
number of degrees.
5. Move the joystick up or down to toggle through the number of degrees (1-40)
until you reach the number you want. (If set on a low number, the scan will
appear to barely move but is still functioning.)
6. SELECT – Press the Iris Open button to select your choice.
CANCEL – Press the Iris Close button if you do not want to change the setting.