C617M-A 8/04 17
PROGRAM UPDATE MENU Use this menu to load a newer version of software into your unit. This menu also shows the current version of software that is in your DVR.
NOTE:
To perform this update, you will need a USB flash drive (32 MB minimum and FAT or FAT32 format) and a PC to access the Pelco
Internet web site (www.pelco.com).
1. Load the new version of software from the Pelco web site onto the USB flash drive. Contact Pelco Technical Support at 1-800-289-9100 if
you need assistance.
2. Refer to Figure 2. Once the new software is on the USB flash drive, insert the USB flash drive into the USB port on the DVR.
3. (Skip this step and step 4 if you are already in the Setup Menu.) Press and hold the Function button. The Function Key List appears. Keep
holding the Function button.
4. Press and release the 0 button, and then release the Function button. Enter the password if requested. The Setup Menu appears.
5. Use the Search (<</>>) buttons to move around within the menu. Highlight Program Update and press the Play/Pause button to select. The
Program Update screen appears unless one of the following conditions exists.
• If there is no update file in the USB flash drive, the error message “File name error” appears and you will be returned to the Setup
Menu.
•If the USB flash drive is not inserted in the DVR, the error message “Device not found” appears and you will be returned to the Setup
Menu.
The Program Update screen shows the current software version in the DVR and the new software version that will be updated from the
USB flash drive.
FUNCTION KEY LIST
0 : Setup
1 : Camera 1 recording/stop
2 : Camera 2 recording/stop
3 : Camera 3 recording/stop
4 : Camera 4 recording/stop
5 : All the cameras recording
6 : All the cameras stop
: Alarm On
: Alarm Off
SETUPMENU
Camera/Audio
All Resolution
Alarm Output
Time
Password
Program Update
Exit
Help: ON
PROGRAM UPDATE
Current Version:
Next Version:
Update Quit