DX8100 System Recovery Procedure
This DX8100 recovery procedure is used in two ways:
•To recover your DX8100 software using the DX8100 Recovery DVD that is provided with the unit.
•To recover your DX8100 Series DVR in case of a catastrophic failure. In this case, this procedure should only be thought of as a last resort endeavor. The recovery process erases the entire contents of your DVR’s primary hard disk drive and overwrites the disk with a fresh image of the system and application software from the DX8100 Recovery procedure.
NOTE: To save the DVR settings before performing the recovery procedure, record the network settings and export and import the DVR settings.
The steps for performing a recovery procedure are summarized as follows:
1.Record the DX8100 network settings.
2.Export the DX8100 settings, to save your camera properties, schedules, and user configurations.
3.Record the IPSec setting.
4.Perform the DX8100 recovery procedure.
5.Perform only the DX8100 import procedure to import the camera properties, schedules, and user configurations that you saved in step 2.
SAVING DVR SETTINGS
RECORDING NETWORK SETTINGS
1.From the DX8100 toolbar, click the Setup icon.
2.Click the Network icon and do the following:
a.Record the DX8100 IP address: ___________________________.
b.Record the subnet mask: ________________________________.
c.Record the default gateway address: ________________________.
d.Indicate if “Obtain an IP Address Automatically” is: Checked_____ Unchecked_____.
e.If Enable Multicasting is selected, record the multicast group IP address________________________.
EXPORTING DVR DX8100 SETTINGS
1.Insert a USB key into one of the DX8100 USB ports on the front panel.
2.Click Edit > Export Setup.
3.
4.Type a name for your backup file in the File name text box, and then click Save. The DX8100 exports the settings to the USB key.
NOTE: Allow 60 seconds for the export process to finish to ensure that all of the DX8100 settings are exported before performing the recovery procedure.
5.To stop the USB device, do the following:
a.From the DX8100 menu, click File > Unplug/Eject Hardware. The Unplug or Eject Hardware dialog box opens.
b.Click Stop. The “Stop a Hardware device” dialog box opens.
c.Select the USB device to which the DX8100 settings are exported.
d.Click OK. The “Safe to Remove Hardware” dialog box opens.
e.Click OK.
f.Click Close.
6.Unplug the USB key.
21 |
