Pelco EA2010 operation manual

EA2010 Post Equalizing

1.0 WARNINGS

Prior to installation and use of this product, the follow-

ing WARNINGS should be observed.

1. Installation and servicing should only be done by

Qualified Service Personnel and conform to all

Local codes.

2. Unless the unit is specifically marked as a NEMA

Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is de-

signed for indoor use only and it must not be in-

stalled where exposed to rain and moisture.

4. Only use replacement parts recommended by

Pelco.

5. After replacement/repair of this unit’s electrical

components, conduct a resistance measurement

between line and exposed parts to verify the ex-

posed parts have not been connected to line cir-

cuitry.

2.0 SCOPE

The information contained within this manual covers

the EA2010 Post Equalizing Video Amplifier.

3.0 DESCRIPTION

The Pelco EA2010 provides a low cost, highly effec-

tive means of maintaining CCTV picture quality in runs

of up to 3000 feet (914.4 m) of RG59 cable.

Through panel controls provided for adjustable overall

amplifier flat gain of 1 to +8 dB plus adjustable high

frequency boost of 0 dB to greater than 18 dB at 12

MHz, mainlining full video amplitude, contrast and

detail.

The EA2010 features all solid-state circuitry and is sup-

plied with a U.L. Listed wall transformer . Applications

should be for POST-EQUALIZATION only (located

near the monitoring equipment); use as a pre-equalizer

is discouraged.

Pelco • 300 W. Pontiac Way, Clovis, CA 93612-5699 • USA • (800) 289-9100 or (1-559) 292-1981

FAX (800) 289-9150 or (1-559) 292-3827 • DataFAX (800) 289-9108 or (1-559) 292-0435

International customers call (1-559) 292-1981 or FAX (1-559) 348-1120