6Pelco Manual C1422M-D (8/05)
ABC
5
C
4
D
B
3
A
B
RED
22 GA. (1 FT.)
BLACK
22 GA. (1 FT.)
TO PC BOARD
TO FAN
2
1
24 VAC MODELS
Figure 1. Exploded Assembly Diagram for Blower
5. Install the sled and camera/lens in the enclosure:
a. If the camera’s lens is adjustable, extend the lens to its maximum length.
b. Place the sled over the mounting screws in the enclosure.
c. Slide the sled forward until the camera’s lens almost touches the window.
d. Tighten the screws to secure the camera sled to the enclosure.
6. Connect the video cable in the enclosure to the video output connection on
the camera.
7. If you are going to synchronize cameras, connect the synchronization cable in
the enclosure to the synchronization connection on the camera.
8. If your camera has a motorized zoom lens control, connect or wire the camera’s
lens control to the LENS or LENS CONTROL connector on the circuit board.
Refer to Figure 2 to see where to connect different lens connector options.