Pelco EH8100 MATING CONNECTOR ASSEMBLY

6C1407M-H (1/07)

MATING CONNECTOR ASSEMBLY

To assemble the 16-pin mating connector, perform the following

steps:

1. Discard the white plastic sleeve that is included with the

connector assembly. Thread the cable through the

compression nut/strain relief and connector shell.

2. Prepare the cabling by doing the following:

a. Strip the outer jacket back 2 inches (5 cm).

b. Strip the individual conductors back 1/4-inch (6 mm)

and thread them into the appropriate holes through

the rubber grommet. Refer to Figure2.

3. Assemble the back of the connector.

4. Solder the individual conductors to the appropriate pins in

the back of the connector (refer to Figure 2). Push the

rubber grommet into the back of the connector.

5. Screw the connector shell to the back of the connector

and tighten. Tighten the compression nut/strain relief as

far as possible to compress the sealing ring inside the

shell. Attach the cable clamps to the compression nut/

strain relief.

CONNECTOR

SHELL

COMPRESSION NUT

AND STRAIN RELIEF

RUBBER

GROMMET

BACK OF CONNECTOR