Pelco ECM100, EPM, EPP important safety instructions

Worldwide Headquarters • 3500 Pelco Way • Clovis, California 93612 USA •

www.pelco.com

USA & Canada • Tel: 800/289-9100 • Fax: 800/289-9150

International • Tel: 1-559/292-1981 • Fax: 1-559/348-1120

C225M-C (11/04)

1. Installation and servicing should only be done by qualiﬁed service personnel and conform to all local codes.

2. Use only installation methods and materials capable of supporting four times the maximum speciﬁed load.

3. Use stainless steel hardware to fasten the mount to outdoor surfaces.

4. To prevent damage from water leakage when installing a mount outdoors on a roof or wall, apply sealant around the bolt holes between the mount

and mounting surface.

This manual contains the installation instructions for the following Esprit

mounts:

EWM Wall Mount Use to mount an Esprit system directly to a load bearing vertical surface.

EPM Pole Mount Use in conjunction with the EWM to mount an Esprit system to a pole.

ECM100 Corner Mount Use in conjunction with the EWM to mount an Esprit system to a building corner.

EPP Pedestal Adapter Use to mount an Esprit system directly to a pedestal mount.

1. Remove the knockouts from the conduit plate. Use the plate as a

template. Mark the conduit and fastener positions onto the mounting

surface. Prepare the surface.

2. Attach the gasket to the end of the EWM.

3. Install the conduit ﬁttings (not supplied).

If conduit is not used, install

sealing glands

(supplied) on the conduit plate. Thread the wiring/cabling

through the conduit plate/sealing glands and EWM wall mount. Attach

the EWM to the mounting surface with the appropriate hardware (not

supplied). Refer to the manual supplied with the Esprit system to

complete the installation.

NOTE:

Refer to Tables A and B for wiring distances.